Documents Similar To Astm c ASTM C – Uploaded by. Alejandro Pinto. ASTM C Uploaded by. Nelson. BS EN Uploaded by. ASTM C Measurement of Rate of Absorption of Water by Hydraulic-Cement Concretes. Lab ID: Use This method is intended to determine the. caused by the deterioration mechanism by the means of the ASTM C C 04 results were then analyzed to validate the applicability of the.
|Country:||Turks & Caicos Islands|
|Published (Last):||10 February 2014|
|PDF File Size:||17.69 Mb|
|ePub File Size:||10.56 Mb|
|Price:||Free* [*Free Regsitration Required]|
Link to Active This link will always route to the current Active version of the standard. Test Method Con the other hand, is used to estimate the maximum amount of water that can asmt absorbed by a dry specimen and therefore provides a measure of the total, water asfm pore space.
By drilling a core and cutting it transversely at selected depths, the absorption can be evaluated at different distances from the exposed surface. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Water absorption is also strongly affected by the moisture condition of the concrete at the asmt of testing.
The test surfaces shall be at the same distance from the original exposed surface of the concrete.
If you need more astk or have any questions, please note the Lab ID number and contact us at:. The core is drilled vertically or horizontally.
The exterior surface is often subjected to less than intended curing and is exposed to the most potentially adverse conditions. The exterior aztm is often subjected to less than intended curing and is exposed to the most potentially adverse conditions.
ASTM C1585 – 13
Print and complete the following order form. The zstm surface of the specimen is immersed in water and water ingress of unsaturated concrete is dominated by capillary suction during initial contact with water.
The surface to be exposed during testing shall not be marked or otherwise disturbed in such a manner as may modify the absorption rate of the specimen. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Use This method is intended to determine the susceptibility of an unsaturated concrete to the penetration of water. The average of test results on at least 2 specimens shall constitute the test result. Instructions Provide at least two concrete cylinders or cores. No other asrm of measurement are included in this standard.
ASTM C Rate of Absorption of Water by Hydraulic Cement | CTLGroup
The core is drilled vertically or horizontally. By drilling a core and cutting it transversely at selected depths, the f1585 can be evaluated at different distances from the exposed surface. If you need more info or have any questions, please note the Lab ID astmm and contact us at: When cores are taken, they should be marked so that the surface to be tested relative to the original location in the structure is clearly indicated. In this test method, only one surface is exposed to water at room temperature while the other surfaces are sealed simulating water absorption in a member that is in contact with water on one side only.
Historical Version s aastm view previous versions of standard. The specimen is conditioned in an environment at a standard relative humidity to induce a consistent asym condition in the capillary pore system.
In general, the rate of absorption of concrete at the surface differs from the rate of absorption of a sample taken from the interior. This test method is used to measure the water absorption rate of both the concrete surface and interior concrete. Order Form 2 Email complete form to contact listed below. This test method is used to measure the water absorption rate of both the concrete surface and interior concrete.
In general, the rate of absorption of concrete at the surface differs from the rate of absorption of a sample taken from the interior.