Kathrein parabolic antennas are made of aluminium and . EXR Single-cable switching matrix with two twin outputs for two receivers;. Therefore exclusively use software provided by Kathrein for your switching matrix (EXR or EXR ) from Kathrein, the LNB you use. If you use a single-cable matrix (EXU ) or a single-cable changeover matrix ( EXR or EXR ) from Kathrein, the LNB you use must be a “Universal.

Author: Vinos Akirn
Country: Paraguay
Language: English (Spanish)
Genre: Education
Published (Last): 1 October 2004
Pages: 166
PDF File Size: 2.26 Mb
ePub File Size: 16.12 Mb
ISBN: 762-7-52873-498-6
Downloads: 47654
Price: Free* [*Free Regsitration Required]
Uploader: Goltiran

TV Program Guide Wed oe. OFT Press the yellow button ksthrein see an alphabetic listing. Only use the unit in a moderate climate, not in tropical conditions!

When you have made your settings, use the to start updating. Then press the Q button. However the channels do change from time to time e. This kathreim assumes that kathreun data has been supplied by the channel provider. If the receiver is locked, it can be operated only by entering the four-digit PIN code after it is switched on factory setting: During this activation period, the CA module and card must be in the slot, and the receiver must be turned on a set to the booked Pay TV channel.

These provide information on what to do next. When all settings have been made, press the ok button to save the recording settings.


Selection and sorting options: Also pay attention to the bars at the bottom of the on-screen display! When you have achieved the desired position, press the oh button to fix the desired position. The details can be different for each CA module.

Restricted Area

Use the QCED buttons to select whether the receiver should automatically change over to and from summer and winter time. The Favorites List can be renamed Start Blockselection: Transponder Frequency Use the C3CED buttons or the numeric keypad to select the transponder frequency on which the channel being sought is transmitted.

If you are unsure whether you chose the right option from a previous menu, you can go FAV back a step at any time during the First Installation process by pressing the red button.

Preface For shorter breaks, you can use the remote control to switch the receiver to standby, which uses only a minimal amount of energy. You can use the cursor buttons Q t0 select tne desired programme and if available you can use the Q button to call up further information on the desired programme.

Confirm your selection with the button. Do not connect the unit to the exrr until all installation work has been properly carried kthrein.

Press the Q or Q button to exit the display. Connection cable PC to receiver: Press the QQ buttons to select this line.


We wish you good reception and much pleasure using your new DVB satellite receiver.

Connections Incorrect wiring of xer connections can lead to malfunctions or defects on the unit! Enter the new four-digit PIN. Antenna configuration menu available using the green button New: You need not refer to this section unless you are carrying out the installation yourself.

Screen display Here you select the type of screen display, depending on the setting of your TV format: A channel can be kzthrein to any Favorites List Start Blockselection: You have the following options: Left L and right R markings see ar- rows illustration 2 The notch spacings on the bottom side Kathrein hdtv satellite receiver operating manual pages.

Kathrein UFS si, UFS sw EXR //

Erx can select a number from one to four satellites to be received. The switching between the two polarisations as well as the selection of the low or the high band and the transponder takes places either directly in the feed system or in the connected one-cable switching matrix. First however the channel must be selected.